Stepper Dirver: Onboard TMC2209 in UART mode, UART address: 00, Rsense: 0.11R.

MCU: ARM Cortex-M0 STM32F072C8T6 48MHz with CAN bus.To Download the datasheet just copy and paste the below link in your browser.

The maximum drain to source voltage is -100V therefore do not drive load of more than -80V, use a proper heatsink with the transistor and always store or operate the transistor in temperature above -55 degree centigrade and above +150 degree centigrade. The Maximum drain to source current is -19A, therefore to not apply load of more than -15.2A. To get long term performance it is better to not use any transistor on its maximum ratings or limits and same applies to IRF9540 transistor. Higher Power Transistor Driver Applications Using the transistor is same as any other general purpose MOSFET is used. IRF9540 can be used in high speed switching purposes, other than that it can also be used in general purposes switching and amplification purposes. Moreover IRF9540 can also be used as a separate audio amplifier or it can also be used in high power audio amplifier stages.

It can also drive load of upto 56A in pulse mode. It also has low gate driving capability due to which the user can operate it directly from the output of ICs or microcontrollers. On the other hand the low drain to source resistance reduces power loss and makes the transistor power efficient. The high switching speed of the transistor can be useful in applications where the designer requires to switch the system or load in nano seconds so the derived circuit will face no disconnection. The transistor possesses high switching speed and low drain to source resistance. The transistor is capable to drive max load of -19A with the load voltage of -100V and the max load in pulse mode can be upto -76A. IRF9540 is a P channel MOSFET transistor that can be used for switching and amplification purposes.

Max Storage & Operating temperature Should Be: -55 to +175 CentigradeĢSJ380, 2SJ464, 2SJ412, IRF9540PBF, SIHF9540.

Drain to Source Resistance in ON State: 200 Ohms.

Max Gate to Source Voltage Should Be: ± 20V.

Max Voltage Applied From Drain to Source: -100V.

Package Type: TO-220, TO-220AB And Other Packages.

Download mosfet pinout for free